RESUMO
Based on the ï¬rst-principles calculations, ferroelectric Bi2O2X (X=S, Se, Te) monolayers with unequivalent in-plane lattice constants are conï¬rmed to be the ground state, which is consistent with the experiment result (Nano Lett. 19, 5703(2019)), and the anisotropic optical property is ï¬rstly investigated. We ï¬nd that the polarizations of Bi2O2X monolayers points along the direction of a-axis, and Bi2O2T e monolayer process the largest polarization. Furthermore, both the biaxial and uniaxial strains are favor for the enhancement of polarization of Bi2O2X monolayers. It should be mentioned that the type of band gap will convert from indirect to direct for Bi2O2T e monolayer when the a-axial tensile strain is larger than 2%. At last, the optical absorption coeï¬cient for Bi2O2X monolayers are calculated, and we obtain that Bi2O2Te monolayer has the strongest optical absorption within the range of visible light, the anisotropy and possible strain engineering to improve the optical absorption are discussed in detail. Our ï¬ndings are signiï¬cant in ï¬elds of optoelectronics and photovoltaics. .
RESUMO
Ferroelectricity is significant in low dimensional structures due to the potential applications in multifunctional nanodevices. In this work, the tailoring angle dependent ferroelectricity is systematically investigated for the nanoribbons and nanowires of puckered group-IV monochalcogenides MX (M =Ge,Sn; X =S,Se). Based on first-principles calculations, it is found that the ferroelectricity of nanoribbon and nanowire strongly depends on the tailoring angle. Firstly, the critical width for the bare nanoribbon of group-IV monochalcogenide is obtained and discussed. As the nanowires are concerned, the ferroelectricity will disappear when the tailoring angle becomes small. At last, H-passivation on the edge and the strain engineering are employed to improve the ferroelectricity of nanoribbon, and it is obtained that H-passivation is beneficial to the enhancement of polarization for nanoribbons tailored near the armchair direction, while the polarization of nanoribbons tailored along the diagonal direction will decrease when the edges are passivated with H atoms, and the tensile strain along the length direction always favors the improvement of ferroelectricity of the considered nanoribbons. Therefore, tailoring angle has great influence on the ferroelectricity of nanoribbons and nanowires, which may be used as an effective way to tune the ferroelectricity and further the electronic structures of nanostructures in the field of nanoelectronics.
RESUMO
Genetic polymorphism has great influences on the improvement of cattle traits. The polymorphism of the same gene family will greatly change the growth traits of cattle, such as the pleomorphic adenoma gene (PLAG) family. Many studies have shown that the PLAG family proteins are the transcription regulators of nuclear protein, which mainly regulates the expression of many important genes in the body. In cattle, single nucleotide polymorphisms (SNPs) within or near the PLAG1 gene is associated with economic traits of height in cattle. Here we investigate a SNPs of bovine PLAG1 in 646 cattle from five breeds. We found three different genotypes by using cleaved amplification polymorphism sequence-tagged sites (CAPs), includes some significant differences in body height, chest circumference and other shapes (Pâ¯<â¯0.05), also we found that the TT genotype had no advantage in body shape. These results indicate that the selection of PLAG1 gene could be used to ensure the breeding direction for growth traits of the beef cattle.